Workshop on New Product Development
Join the 2-Day Workshop on New Product Development using Additive Manufacturing Technologies organized by the Center of Excellence for Additive Manufacturing, Ajay Kumar Garg Engineering College (AKGEC).
27 Nov - 28 Nov
Ghaziabad
₹10
About Event
Workshop on New Product Development
🚀 2-Day Workshop on New Product Development using Additive Manufacturing Technologies
The Center of Excellence for Additive Manufacturing, established under the UP Startup Policy (Department of IT & Electronics, Government of Uttar Pradesh) at Ajay Kumar Garg Engineering College (AKGEC), Ghaziabad, invites startups, innovators, entrepreneurs, researchers, and product developers to participate in an intensive two-day workshop focused on New Product Development through Additive Manufacturing (3D Printing).
Why Participate
More than just a hackathon.
🏆
Hands-on learning in Additive Manufacturing (3D Printing)
A key benefit available to participants in this event.
🚀
Reverse Engineering fundamentals
A key benefit available to participants in this event.
🤝
Design for Additive Manufacturing (DfAM) techniques
A key benefit available to participants in this event.
🏆
Exposure to the startup and innovation ecosystem
A key benefit available to participants in this event.
🚀
Practical insights for building market-ready products
A key benefit available to participants in this event.
Speakers & Mentors
Learn from AI researchers and founders.
AKG Innovation & Foundation
Incubation Center · Ajay Kumar Garg
Incubation Center
Schedule
48 hours of building and innovation.
27 Nov, 9:00 am
Registration & Participant Check-in
Registration, welcome kit distribution, and networking.
27 Nov, 9:30 am
Inaugural Session
Welcome address and introduction to the Center of Excellence for Additive Manufacturing